Dave Smith Instruments Pro 2 Manual de usuario descargar pdf (Pagina 42)

32 Amplier Envelope

Dave Smith Instruments

To create a program in which velocity controls the VCA, turn vca envelope

amount down and turn velocity amount up. To achieve the best results, it may be

necessary to set an initial level using Envelope Amount. Just remember that once

Envelope Amount is set to the maximum, no modulation from velocity—or any other

source—will cause it to go higher than that.

Env Repeat: Off, On—(In the vca env amount tab of the display)

When on, the Delay, Attack, and Decay segments of the envelope

repeat. Sustain still affects the level at which the Decay segment ends,

but instead of sustaining at a xed level while a note is gated on, Delay,

Attack, and Decay loop until the note is turned off. The Release segment

begins when the note is gated off, just as it does when Repeat is off. See

the illustration below.

Off

A: The gate generated by pressing, holding, and then releasing a key.

B: Corresponding DADSR envelope behavior with Delay on and Repeat off.

C: Behavior of the same envelope with Repeat on.

Distortion: 0…127—(In the vol/dist tab of the display) Sets the

amount of analog distortion applied to a program.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 151 152

Sin comentarios

Dave Smith Instruments Pro 2 Manual de usuario Pagina 42