
16 Oscillators
Dave Smith Instruments
Frequency Modulation (FM): 0…127—
Allows one oscillator—called the
modulator, for the purposes of FM synthesis—to modulate the frequency of
another oscillator—called the carrier. The arrows between the oscillator select
buttons show the modulator/carrier relationship between the oscillators, as does
the following table.
Carrier Modulator
Oscillator 1 Oscillator 2
Oscillator 2 Oscillator 3
Oscillator 3 Oscillator 4
Oscillator 4 Oscillator 1
Turning up FM for oscillator 1 causes it to be modulated by oscillator 2, turn-
ing up FM for oscillator 2 causes it to be modulated by oscillator 3, and so on.
Note: The indicated order of modulation is really just a handy shortcut. In
fact, you can route any oscillator to another using the modulation matrix. See
Modulation on page 32 for more information.
Amplitude Modulation (AM): 0…127—
As with FM, AM uses the oscillators
as carrier/modulator pairs. But with AM, the modulator modulates the carrier’s
amplitude, not its frequency. As with FM, any oscillator routing combination can
be congured using the modulation matrix.
Glide Amount: 0...127
—Sets the oscillator glide (portamento) amount. Glide
can be set independently for each oscillator. Low values are shorter/faster. The
glide switch must be on to hear the effect of glide amount. For a detailed expla-
nation, see Glide on page 36.
Tip: To set glide amount for all oscillators simultaneously, press and briey
hold any of the oscillator select buttons until all of them are lit. Repeatedly
press Prev and next Param (Soft keys 2 & 3) until glide is displayed. Press
and hold, Hold: edit all (Soft key 1) while adjusting one of the soft knobs.
Press any oscillator button to exit.
Slop: 0…127—
Adds random detuning to the oscillator to emulate the tuning
instability of voltage controlled analog oscillators, from subtle, barely perceptible
amounts to wildly out of tune.
Oscillator 1 Sub Octave: 0…127—
Controls the level of a sine wave oscilla-
tor pitched one octave below oscillator 1.
Comentarios a estos manuales